Welcome to Ivy Metering!

DTS353-D513049-01

1. Brief IntroductionThis is a three phases DLMS multifunctional energy meter which was warmly welcomed in South-American due to standard installation. It equipped RS485, IR, RF etc communication meth...

DLMS multifunctional meter
  • DLMS multifunctional meter
4
  • Product Details
  • 1. Brief Introduction

    This is a three phases DLMS multifunctional energy meter which was warmly welcomed in South-American due to standard installation. It equipped RS485, IR, RF etc communication method, four tariffs, relay optional and CTT certificate.

     

     

    2. Technical Parameter

    Ref. voltage

    3*120/208V 3*127/220VAC

     

    Ref. current

    5(100)A

    Impulse constant

    6400imp/kWh

    Ref. frequency

    60Hz

    Accuracy class

    Cl.1

    Communication

    RS485 DLMS protocol

    LCD display

    6+2

    Starting current

    0.4%Ib(Cl.1)

    Power consumption

    Voltage circuit:<2W/<10VA ; Current circuit:<2.5VA

    Protection level

    IP54

    Anti-UV rating

    V3Flame retardant rating V2


    3. Function Description

    The meter can display voltage, current, active power, reactive power, date and time on the LCD display.l

    Active and reactive power measurement, bidirectional measurement, input power and output power, instantaneous powerl

    Built-in 100A relay controls the opening and closing of the meter through communication

    Support RS485, IR communication (DLMS) and RF communication (custom)

    RS485: Baud rate 9600 (fixed), 8-bit data. Parity check. One stop bit

    IR: baud rate 9600 (fixed), 8-bit data, parity, one stop bit

    RF: Baud rate 9600 (fixed), 8-bit data, no parity. One stop bitl

    RF communication is only for home displayl

    Load the configuration file for 15 minutes for 6 monthsl

    Anti-stealing function: through accurate measurement and alarm (must send alarm signal through RS485 interface)l

    Other alarms: relay disconnection, over-voltage, buck, reverse, power offl

    FW upgrade through RS485 communication interfacel

    Event record: over voltage, low voltage, terminal cover open (open cover detection), password change, etc.l

    Local (IR) and remote upgrade (RS485)l

    No need to change the password by button